Cylinder Boring Pricing
  • $99.00 - Bore and hone each cylinder
  • $25.00 - Hone only each cylinder
  • $20.00 - Additional if boring exceeds 2 mm
  • $20.00 - Remove and replace studs
  • $20.00 - Scrap gaskets off cylinder
  • $69.50 - Service power valves
Cylinder Head Pricing
Base Price:
Disassemble Head, Clean-Prep Casting, Reassemble Head
  • 2-Valve Single Cylinder $99.00 + Parts if needed
  • 4-Valve Single Cylinder $149.00 + Parts if needed
  • 5-Valve Single Cylinder $198.00 + Parts if needed
Note* Base price is required for all cylinder head work (Example: 4-Valve Head = $149 + additional services and parts below)

Valve Job

Re-cut Seat
  • $29 per seat
Replace Seat / Valve Job
Remove damaged/worn seat, press in new seat and valve job
  • $69 each + price of each seat
Replace Guide / Valve JobRemove damaged/worn guide, install new guide, ream and hone to size and valve job
  • $69 each + price of each guide
Replace Seat / Replace Guide / Valve JobRemove damaged/worn guide, install new guide, ream and hone to size, replace seat and valve job
  • $89 each + price of each seat and guide

Crankshaft Pricing

We Rebuild Yours
  • Single Crankshafts - *$139.00 + parts

Dyno Tuning

Base Run Only
  • $200.00 - Includes set up and a few pulls on the dyno. You will receive a chart with horsepower and torque.  
Carburetor
  • Starting at $675.00* - Includes set up, up to 3 hours of dyno tuning (Pulling carburetor and re-jetting), jets, and dyno charts (Horsepower and Torque) before and after.
 
Engine Disassemble & Inspection Pricing
  • Single Cylinder - Starting at $278.00*
  • Twin Cylinder - Starting at $417.00*
We do not service motorcycles (street bikes), PWC (jet ski) or snowmobiles. 
*This price includes disassembling the engine, full inspection (measure tolerances and check for wear) and provide a complete written estimate to rebuild your engine. This service is the "getting started price" we need to be able to provide an accurate estimate. Keep in mind this price will go towards the final repair bill. The only additional cost will be re-assembly labor, special operations (cylinder boring, nikasil re-plating, crankshaft rebuild, etc.) and parts.
Note: "Ball Park" estimates can sometimes be provided but are not the guaranteed price for your engine rebuild. If we had it our way, we would never quote prices over the internet but we understand you need an idea of what it might cost. Once we tear down and inspect your engine will we be able to provide you an accurate estimate.
Suspension PricingDirt Bike Forks & ShocksForks (Pair Off Bike) $139.00 + Parts
Shock (Off Bike) $109.00 + Parts
Side by Side ShocksShock (Off Side by Side) $109.00 + Parts
ATV ShocksShock (Off ATV) $109.00 + Parts